Epoxy Coatings
Our epoxy system goes over concrete we grind first and ends in a sand finish for grip. It suits workshops, utility and laundry rooms, basements and commercial floors.
Learn More
Kissimmee spreads out from a historic downtown by the banks of Lake Tohopekaliga. Most of the city sits on flat sand with a seasonal high water table. NRCS soil maps rate about 95 percent of its land somewhat poorly to very poorly drained. A garage slab on that ground can draw moisture up from below, and too much can make a coating peel.
Armor Garage Flooring installs garage floor coatings in Kissimmee for homeowners and businesses. Kissimmee is part of our service area across Polk County and the Four Corners side of Central Florida. Our main garage system is a polyaspartic coating with a full flake broadcast, over concrete we grind first. Call or text (866) 282-7667 for a free estimate.
Tell us about the garage, patio, driveway or shop floor and where it is. We look at the job and put your free estimate in writing.
Much of Kissimmee's housing has some age on it. The Census Bureau's 2020 to 2024 survey puts the median year built for the city's homes at 1992. More of the city's homes date to the 1980s than to any other decade.
The Osceola County Property Appraiser's records show 17,851 single-family homes inside the city. About 36 percent date to 1980 through 1999. About 8 in 10 have an attached garage, and the median one measures about 420 square feet.
A garage slab from the 1980s or 1990s may carry oil stains or an old coat of paint. We grind the concrete to take off the weak top layer and open it for the coating. Cracks get filled first, since flaws left open show through the finish. Then a full flake finish covers the slab edge to edge in color chips, sealed under a clear topcoat.
Most of Kissimmee sits on flatwoods sand. NRCS maps Myakka fine sand, Florida's official state soil, across nearly half of the city, much of it built over. Basinger fine sand, which NRCS rates very poorly drained, covers about another eighth.
NRCS says Myakka's water table sits within 18 inches of the surface for 1 to 4 months in most years. Across about 89 percent of city land, NRCS maps a water table that high for part of the year. In very dry seasons, Myakka's water table drops below 40 inches.
NOAA's Kissimmee weather station logs about 52.6 inches of rain in a normal year. About 30.7 inches of it falls from June through September. For slabs out in that rain, our patio and lanai coatings carry a textured finish for grip when wet.
A slab over wet sand can draw moisture up from below. Coating makers call for a moisture test first, such as a calcium chloride test or probes set into the slab. When a slab tests above the coating's limit, a moisture-blocking primer goes on before the base coat.
Humid air matters on install day too. At Orlando International Airport, NOAA's dew point normals run about 73 to 74 degrees in July and August. Coating makers' data sheets want the slab at least 5 degrees warmer than the dew point.
Osceola County keeps growing. The Census Bureau puts its population at 481,718 in July 2025, up about 24 percent from 2020. In 2025, permits went out for 5,085 new single-family homes across the county. Only 167 were inside the City of Kissimmee, and 3,488 were in the unincorporated county.
Inside the city, most new homes go up in larger buildings. The city permitted 799 units in buildings of five or more units in 2024, and 380 in 2025. Florida's official list shows 49 active community development districts created by Osceola County, and 4 by the city. These public districts pay for the roads and utilities of master-planned communities.
Vacation homes cluster west and southwest of the city. The 2020 Census counted homes held for seasonal or occasional use, the group that takes in vacation homes. Inside Kissimmee, about 1 in 30 homes fell in that group. In ZIP 34746, southwest of downtown, it was about 1 in 8.
In ZIP 34747, which takes in Celebration and Reunion to the west, it was nearly 3 in 10. A coated garage floor is easy to clean between stays.
Kissimmee is the Osceola County seat, but the city and the county issue permits separately. Which office you ask depends on which side of the city line your home sits on.
Inside the city, it is the City of Kissimmee's Building and Permitting Division. Its permits page puts it this way: "You may have heard that Florida no longer requires building permits. That's not quite right."
The page says most home projects still need a permit. Even when one is not needed, you must notify the City first. The city's page on the 2026 rules adds that any work in a designated flood zone always needs a permit.
Neither page names floor coatings, so ask the division about your project. It will confirm a property's flood designation, its page says.
Outside the city line, most homes go to Osceola County's Community Development Department. Its permit page lists painting and replacing flooring among work that needs no permit. It does not name floor coatings.
The city's page on the 2026 rules also says to follow your HOA's separate rules. Under Florida law, an HOA reviews a home's exterior look only as far as its covenants and guidelines allow. Check them before a driveway or front entry gets a coating. Our driveway coatings use a UV-stable topcoat made for full Florida sun.
Communities and areas we serve around Kissimmee: Downtown Kissimmee, Lake Tohopekaliga, Kissimmee Lakefront Park, Shingle Creek Regional Park, Osceola Heritage Park, Buenaventura Lakes, Celebration, Reunion, Four Corners, US 192, John Young Parkway, Osceola Parkway.
Kissimmee ZIP codes served: 34741, 34743, 34744, 34746.
Kissimmee is part of our service area. We look at the job and put your free estimate in writing.
(866) 282-7667
Our epoxy system goes over concrete we grind first and ends in a sand finish for grip. It suits workshops, utility and laundry rooms, basements and commercial floors.
Learn More
Our main garage floor system pairs a polyaspartic coating with a full flake broadcast. It cures fast and holds its color in the sun.
Learn More
Our polyurea floor coatings start with a polyurea or hybrid epoxy/polyurea base coat on ground concrete. Flake is broadcast to rejection, and a clear polyaspartic topcoat seals the floor.
Learn More
A full flake floor covers the slab in color chips, edge to edge, under a clear topcoat. Pick a flake blend to match your style.
Learn More
A quartz floor coating puts two broadcasts of colored quartz into the coating, then a clear topcoat. The textured finish has no grout lines, and it suits restaurant kitchens, commercial floors and pool decks.
Learn More
Polyaspartic flake coatings for concrete driveways and the slabs around them. A UV-stable topcoat and a textured finish suit Florida sun and rain.
Learn More
We coat patios, lanais, screened porches and walkways around Eagle Lake and Polk County. A textured flake or sand finish gives the slab grip when it is wet.
Learn More
We coat the concrete deck around a pool with a sand or quartz finish. The texture gives the deck grip when it is wet, and a clear, UV-stable topcoat seals it.
Learn More
Armor Garage Flooring coats shop floors, warehouses, service bays and showrooms. Working floors get a sand-finish epoxy system matched to their traffic and spills.
Learn MoreA few of the questions we hear most around Kissimmee. If yours is not here, call or text and ask.
Tell us about the floor you want coated and where the property is. Call or text (866) 282-7667 or use the form, and we will set up your free estimate.
Tell us about the garage, patio, driveway or shop floor and where it is. We look at the job and put your free estimate in writing.